Editorial Reviews:
Product Description
Mennon CCD sensor and 45 -reflex mirror cleaner is the perfect solution to keep your pictures clear. It comes with extension tube, CCD cleaning tip and brush. Instruction for Use: # Set the shooting mode to M (Manual), so that you can set the shutter speed to "B". # Switch to MF (Manual Focus)mode, cause in AF(AutoFocus) mode the camera will permanently try to focus in vain, when you remove the lens. # Remove the lens of the camera. # Keep the shutter release button pressed down, so that the shutter remains open during cleaning. We recommend to use a cable shutter release to fixate the release button in pressed down position. # Mount the extension tube and the CCD cleaning tip on the CC-1 and switch it on. Then lightly wipe the surface of the CCD sensor with the soft rubber blade of the CCD cleaning tip 2-3 times without any pressure. # In the same way you can clean the 45 -reflex mirror of (D)SLR cameras, carefully avoiding any pressure, cause the reflector easily can be broken. # To check the cleaning success, remount the lens, set the aperture to the smallest and photograph a white paper full format. Any remaining dust on the CCD shows on the picture. IMPORTANT NOTES: * Before cleaning a CCD make sure that the camera's batteries are fully charged. Low power lets the shutter close. If that happens while you are cleaning the CCD, the shutter might be severely damaged. * CCD-cleaning should be done only indoors in a dust free environment. The temperature should be above 5 C, cause otherwise the camera's batteries might fail. * Usually the dust on CCDs consists of loose, non-sticky particles. You can wipe and vacuum it away without using any chemical solvents. * Clean both sides of the rubber blade of the CCD tip with the included brush, before and after cleaning. * The rubber blade of the CCD tip is sensitive. Do not use it on other surfaces than the CCD sensor and reflex mirror surface. * The CC-1 uses 4 AA batteries. For best vacuum performance fully charge th
|
